[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: using por numbers in selectors

To: smb+lists@research.att.com (Steven M. Bellovin)
Subject: Re: using por numbers in selectors
From: Clemen Jue <clemenj@hpinrput.cup.hp.com>
Date: Tue, 22 Jun 1999 15:24:13 -0700 (PDT)
Cc: ipsec@lists.tislabs.com
In-Reply-To: <19990622153551.132E841F16@SIGABA.research.att.com> from "Steven M. Bellovin" at Jun 22, 99 11:35:45 am
Sender: owner-ipsec@lists.tislabs.com

> 
> Do any commercial IPSEC implementations use port numbers in their
> policy databases?  The ones I've looked at this far seem to use only
> IP addresses.

The HP/9000 implementation supports port numbers as well.

Clemen Jue
Hewlett-Packard

References:

using por numbers in selectors

From: "Steven M. Bellovin" <smb+lists@research.att.com>

Prev by Date: Re: using por numbers in selectors
Next by Date: Re: using por numbers in selectors
Prev by thread: Re: using por numbers in selectors
Next by thread: Re: using por numbers in selectors
Index(es):
- Main
- Thread