[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: using por numbers in selectors

To: ipsec@lists.tislabs.com, "Steven M. Bellovin" <smb+lists@research.att.com>
Subject: Re: using por numbers in selectors
From: "Valery Smyslov" <svan@trustworks.com>
Date: Wed, 23 Jun 1999 10:51:10 +4
Comments: Authenticated sender is <svan@ss10>
In-reply-to: <19990622153551.132E841F16@SIGABA.research.att.com>
Organization: TWS
Sender: owner-ipsec@lists.tislabs.com

On 22 Jun 99 at 11:35, Steven M. Bellovin wrote:

> Do any commercial IPSEC implementations use port numbers in their
> policy databases?  The ones I've looked at this far seem to use only
> IP addresses.

TrustWorks products support port numbers.

Valery.

References:

using por numbers in selectors

From: "Steven M. Bellovin" <smb+lists@research.att.com>

Prev by Date: IPsec-implementations for Linux kernel 2.2.*
Next by Date: FW: IPsec-implementations for Linux kernel 2.2.*
Prev by thread: Re: using por numbers in selectors
Next by thread: RE: using por numbers in selectors
Index(es):
- Main
- Thread