[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: about Selecter Parameter
Makoto,
>In RFC2401;
>>
>> 4.4.2 Selectors
>> .....
>> - Destination IP Address (IPv4 or IPv6): this may be a single IP
>> address (unicast, anycast, broadcast (IPv4 only), or multicast
>> group), a range of addresses (high and low values (inclusive),
>> address + mask, or a wildcard address. The last three are used
>> .....
>> transport'd packet, there will be only one IP header and this
>> ambiguity does not exist. [REQUIRED for all implementations]
>
>Is this sentence saying,
>when implementing SPD, the implementor Must support *ALL* parameters
>setting below for dest-IP ?
> - single IP
> - multicast
> - a range of addresses (high and low values
> - address + mask
> - a wildcard address
>
>or,
>are these only candidate of dest-IP setting and whole parameter's support
>being not mandatory?
It is mandatory (REQUIRED) for an implementation to support ALL of these
parameter types, to facilitate interoperability.
Steve
References: