[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: using por numbers in selectors

To: "Steven M. Bellovin" <smb+lists@research.att.com>, <ipsec@lists.tislabs.com>
Subject: RE: using por numbers in selectors
From: "Partha Bhattacharya" <pbhattac@cisco.com>
Date: Tue, 22 Jun 1999 12:55:47 -0700
Importance: Normal
In-Reply-To: <19990622153551.132E841F16@SIGABA.research.att.com>
Sender: owner-ipsec@lists.tislabs.com

The current Cisco IOS implementation supports port numbers as well. 

> -----Original Message-----
> From: owner-ipsec@lists.tislabs.com
> [mailto:owner-ipsec@lists.tislabs.com]On Behalf Of Steven M. Bellovin
> Sent: Tuesday, June 22, 1999 8:36 AM
> To: ipsec@lists.tislabs.com
> Subject: using por numbers in selectors
> 
> 
> Do any commercial IPSEC implementations use port numbers in their
> policy databases?  The ones I've looked at this far seem to use only
> IP addresses.
> 
> 
>

References:

using por numbers in selectors

From: "Steven M. Bellovin" <smb+lists@research.att.com>

Prev by Date: Re: using por numbers in selectors
Next by Date: RE: using por numbers in selectors
Prev by thread: Re: using por numbers in selectors
Next by thread: RE: using por numbers in selectors
Index(es):
- Main
- Thread