[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: using por numbers in selectors

To: "Steven M. Bellovin" <smb+lists@research.att.com>
Subject: Re: using por numbers in selectors
From: "Scott G. Kelly" <skelly@redcreek.com>
Date: Tue, 22 Jun 1999 10:16:40 -0700
CC: ipsec@lists.tislabs.com
Organization: RedCreek Communications
References: <19990622153551.132E841F16@SIGABA.research.att.com>
Sender: owner-ipsec@lists.tislabs.com

"Steven M. Bellovin" wrote:
> 
> Do any commercial IPSEC implementations use port numbers in their
> policy databases?  The ones I've looked at this far seem to use only
> IP addresses.

RedCreek will be supporting ports in an upcoming release.

Follow-Ups:

Re: using por numbers in selectors

From: Slava Kavsan <bkavsan@ire-ma.com>

Re: using por numbers in selectors

From: Dan Harkins <dharkins@network-alchemy.com>

References:

using por numbers in selectors

From: "Steven M. Bellovin" <smb+lists@research.att.com>

Prev by Date: Re: draft-ietf-ipsec-notifymsg-00.txt
Next by Date: Re: using por numbers in selectors
Prev by thread: using por numbers in selectors
Next by thread: Re: using por numbers in selectors
Index(es):
- Main
- Thread