[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: using por numbers in selectors

To: "Scott G. Kelly" <skelly@redcreek.com>
Subject: Re: using por numbers in selectors
From: Slava Kavsan <bkavsan@ire-ma.com>
Date: Tue, 22 Jun 1999 13:48:00 -0400
CC: "Steven M. Bellovin" <smb+lists@research.att.com>, ipsec@lists.tislabs.com
References: <19990622153551.132E841F16@SIGABA.research.att.com> <376FC4F8.E53D3DB4@redcreek.com>
Sender: owner-ipsec@lists.tislabs.com

IRE IPSec Client supports port selectors

"Scott G. Kelly" wrote:

> "Steven M. Bellovin" wrote:
> >
> > Do any commercial IPSEC implementations use port numbers in their
> > policy databases?  The ones I've looked at this far seem to use only
> > IP addresses.
>
> RedCreek will be supporting ports in an upcoming release.

--
Bronislav Kavsan
IRE Secure Solutions, Inc.
100 Conifer Hill Drive  Suite 513
Danvers, MA  01923
voice: 978-739-2384
http://www.ire.com

References:

using por numbers in selectors

From: "Steven M. Bellovin" <smb+lists@research.att.com>

Re: using por numbers in selectors

From: "Scott G. Kelly" <skelly@redcreek.com>

Prev by Date: Re: using por numbers in selectors
Next by Date: Re: using por numbers in selectors
Prev by thread: Re: using por numbers in selectors
Next by thread: Re: using por numbers in selectors
Index(es):
- Main
- Thread